Seac Pinne BM30 Fins Black
SEAC BM-30 - THE LAUNCH OF FRC™ TECHNOLOGY IN THE LATEST SEACSUB FIN MADE IN ITALY
Description
Seac Pinne BM30 Fins Black
With the new SEAC BM-30 fins, Seacusb launches the new FRC™ technology - Fully Responsive Compound.
It all started with the search for a mixture of polymers that would allow the San Colombano company Certenoli to produce fins with performance similar to those of carbon and glass fiber, while eliminating the well-known problems of fragility of these compounds.
Thus, they have arrived at a compound with unprecedented mechanical characteristics that Seacsub's design and production experience has transformed into a new technology dedicated to the production of fins with even higher performance.
The FRC™ - Fully Responsive Compound technology has therefore met all of Seacsub's production requirements:
- Negative fins and fin blades that are thinner than their technopolymer predecessors thanks to the fluidity and specific weight of the material.
- The product design takes advantage of the mechanical properties of the composite for an elastic response similar to that of carbon and fiberglass.
- There is no risk of breakage or permanent deformation thanks to the high resilience of the compound and its high elastic limit and tear resistance, even at low temperatures.
- The resistance and high modulus of elasticity allow you to take full advantage of the typical geometry of carbon and fiberglass blades without having to use reinforcing ribs or protections.
- Reduced carbon footprint compared to the usual technopolymers used in the industry and total absence of toxic elements.
The particularity of the SEAC BM-30 fins lies, therefore, in this technology that combines innovative materials with hydrodynamic and ergonomic geometries.
The compound used is so elastic and has such a high shape memory that - in an absurd demonstration - if we looked at the blade after rolling it on itself, once released it would continue to have its initial geometry, without any permanent structural deformation that could compromise its performance.
Like the successful Motus series, the short fin upper of the BM-30 is made with two different materials, one more rigid in the sole to provide stability and another softer in the upper part to offer maximum comfort during use. dragged on.
The blade of the SEAC BM-30 fins has a 30° angle to facilitate both finning on the surface and to adapt to the natural inclination of the ankles during the dive. The small stabilizing fins located at the end of the blade, at the point of greatest water flow, prevent the fin from moving laterally without compromising its correct bending.
SEAC BM-30 fins are 100% Made in Italy, produced in Seacsub's solar-powered factory.